Making an Attic Access Door

0

The attic access door to the attic is often the name used to describe any type of panel push up, French doors knees or other input to attic space. The most common of these is the door to push up, which is nothing more than a drywall or plywood fastened by simple adjustments for wood. These panels are often found in hallways, closets, garage spaces, or areas of the house where the panel will not be very noticeable, and yet provide easy access for storage or maintenance.

Select a roof or ceiling hallway closet with good space, and you have to use a ladder to attic access door. Spend the metal detector through your roof to locate the joists. Mark each location with a pencil. Your beams should be 40.64 to 60.96 cm in the center. This is wide enough for a panel.

Measure and draw attic access door the width between the rafters and 71.12 to 76.20 cm for the panel length. Use a drywall saw and cut first along your lines of beams. You must feel to the mountains touch the face of the beam to cut. Make your cross cuts with a knife. You are trying to save the panel plaster, therefore, working slowly to make clean cuts.

Comments are closed.